Wacker Neuson BH 23 Operator's Manual download pdf (Page 28)

8 Transport

Performing preparations

1. Switch off the engine.

2. Remove tool.

3. Lean the machine upright against a solid object and secure it to prevent it

from toppling over.

Wacker Neuson recommends to hang the machine on the truck.

4. Let machine cool off.

Emptying the fuel system

Note: The fuel cap has a pressure relief and vacuum valve through which fuel

can escape when it is warm (e.g. in direct sunlight).

The fuel system must be empty during transport in order to prevent fuel from es-

caping through the pressure relief valve.

1. Remove any dirt around the fuel cap.

2. Unscrew and remove fuel cap.

3. Pump the fuel out into a suitable container or tank, e.g. with a suction pump.

4. Position the fuel cap and tighten it.

5. Start the engine and let it idle until the fuel in the carburetor is used up and

the engine stops.

Transporting the machine

1. Lift machine with the supplementary handle.

2. Place the machine on or into a suitable means of transport.

3. Secure the machine against falling over and down or sliding.

Note: Wacker Neuson recommends to use the truck for the transport on the

construction site, refer to chapter Accessories.

WARNING

Improper handling can result in injury or serious material damage.

f Read and follow all safety instructions of this operator's manual, see chapter

Safety.

WARNING

Danger of fire and explosions by fuel.

Any fuel that escapes can ignite and cause severe burns.

f Lift and move the machine in the upright position.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 67 68

No comments

Wacker Neuson BH 23 Operator's Manual Page 28