Wacker Neuson Cub 200 Operator's Manual download pdf (Page 41)

HI 110 / 200 / 300 Burner Setup

ghi_tx001449gb.fm 41

6.5 Checking/Changing the Burner Nozzle

Prerequisites

 Machine shut down and cool to the touch

 Machine properly positioned

When

Replace the burner nozzle annually, or if it is damaged.

To replace the burner nozzle, carry out the following procedure.

Removing the

nozzle

1. Remove the burner. See topic Removing and Installing the Burner Assembly.

2. Place an adjustable wrench on the large fitting (a) on the nozzle base (c).

3. Place another adjustable wrench on the nozzle (b).

4. Rotate the nozzle counter-clockwise and remove it from the assembly.

Installing the

nozzle

5. Install the new nozzle (b) onto the nozzle base (c).

6. Tighten the nozzle (b) using an adjustable wrench. Rotate the wrench

clockwise.

7. Reinstall the burner assembly. See topic Removing and Installing the Burner

Assembly.

CAUTION

Hot surface hazard. The machine surfaces may be hot.

f Allow the machine to cool for a minimum of ten minutes before touching it.

r007408

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 63 64

No comments

Wacker Neuson Cub 200 Operator's Manual Page 41