Wacker Neuson GPSi 3200 Operator's Manual download pdf (Page 38)

Operation GPi 3200 / 4300

38 wc_tx001875gb.fm

Connecting

and charging

a battery

Follow the procedure below to connect and charge a battery.

1. Connect the positive terminal (e1) (red) on the generator to the positive (+)

battery terminal.

2. Connect the negative terminal (e2) (black) on the generator to the negative (-)

battery terminal.

3. Charge the battery for the recommended length of time prescribed by the

battery manufacturer.

Disconnecting

the battery

When the battery is fully charged:

1. Disconnect the cable from the negative (-) terminals of the battery and the generator.

2. Disconnect the cable from the positive (+) terminals of the battery and the generator.

If the DC

circuit breaker

activates

The DC circuit breaker (f) may activate while a battery is charging. This may occur

for either of the following reasons:

 Defective battery—check the battery before replacing the DC breaker



Excessive current draw from a large capacity battery or a totally discharged

battery—use an AC battery charger to charge the battery instead of the generator.

3.19 Stopping the Generator

Before

stopping

Inform other personnel on the jobsite that power is being turned off. Make sure that

the power shutdown will not create any hazards by turning off devices such as

pumps, heaters, or lights that may need to be kept on.

Stopping

procedure

To stop the generator:

1. Switch off and disconnect all equipment from the generator.

2. Allow the generator to run at no load for approximately 3 minutes.

3. Turn the engine switch (h) to the STOP position.

4. (Electric start models only): Turn the key switch (g) to the “O” (STOP) position.

r006678

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 67 68

No comments

Wacker Neuson GPSi 3200 Operator's Manual Page 38