Wacker Neuson GPSi 3200 Operator's Manual download pdf (Page 33)

GPi 3200 / 4300 Operation

wc_tx001875gb.fm 33

3.15 Starting the Generator (S Models)

Starting

procedure

Follow the procedure below to start the machine.

1. Turn the engine switch (h) to the CHOKE position (or the RUN position if the

engine is warm or the ambient temperature is high).

2. Insert the starting key into the key switch (g).

3. Turn the starting key clockwise to the “I” (ON) position, then farther to the

START position. The engine will start.

NOTICE: To avoid machine damage, do not engage the starter motor continuously

for more than five seconds. If the engine fails to start, return the starting key to the

ON position, wait approximately 10 seconds, and then try again.

Do not turn the key switch to the START position when the engine is running.

4. If you started the engine with the engine switch in the CHOKE position, allow the

engine to run for 20–30 seconds and then turn the engine switch to the RUN

position.

5. Use the LED changeover switch (n) to switch to display voltage on the LCD. A

reading of 120V indicates that the generator is operating properly.

Troubleshooting

 If the engine does not start after several attempts, repeat the starting procedure

with the engine switch turned to the RUN position.

 Try starting the machine manually. See Starting the Generator (Manual Start

Models).

 If the engine still does not start, refer to the Troubleshooting chapter.

CAUTION

Personal injury or machine damage hazards. Starting the generator with equipment

attached can damage the generator or the equipment. Unexpected equipment

start-up can cause personal injury.

f Disconnect all equpment from the generator before starting it.

wc_gr006666

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 67 68

No comments

Wacker Neuson GPSi 3200 Operator's Manual Page 33