Wacker Neuson GPSi 3200 Operator's Manual download pdf (Page 42)

Maintenance GPi 3200 / 4300

42 wc_tx001240gb.fm

4.3 Checking the Engine Oil

When

Check engine oil daily before starting the engine, or more than 5 minutes after

stopping the engine.

Prerequisites

 Engine is stopped

 Machine is on a level surface

 Fresh oil is available (see Technical Data for type and quantity)

Procedure

Follow the procedure below to check the engine oil level.

1. The oil filler cap (O) with level gauge is located at the rear of the machine below

the engine exhaust pipe.

2. Unscrew and remove the oil filler cap from the oil fill port.

3. Wipe the level gauge clean and insert it into the oil fill port.

4. Remove the level gauge from the oil fill port and check the oil level. The oil level

should fall between the upper and lower marks (O1, O2).

5. If the oil level is too low, add oil until the level reaches the upper mark (O1).

6. Reinstall the oil filler cap and tighten it securely.

Note: Change the oil if it appears dark, dirty, or contaminated. See “Changing the

Engine Oil.”

WARNING

Burn hazard. The engine and exhaust pipe become extremely hot during operation.

f Stop the engine and allow the machine to cool before checking the engine oil.

wc_gr006663

WARNING

Most used oil contains small amounts of materials that can cause cancer and other

health problems if inhaled, ingested, or left in contact with skin for prolonged

periods of time.

f Take steps to avoid inhaling or ingesting used engine oil.

f Wash skin thoroughly after exposure to used engine oil.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 67 68

No comments

Wacker Neuson GPSi 3200 Operator's Manual Page 42