Wacker Neuson GPi 1700 Operator's Manual download pdf (Page 30)

Operation GPi 1700

30 wc_tx001234gb.fm

2.15 Using DC Power

Overview

The DC terminals (v) are to be used only for charging 12V batteries. Maximum

available power is 12V–8.3A (100W).

Both AC and DC output can be used at the same time provided that the total output

falls below the maximum rated output of the generator.

Prerequisites

 Verify that pilot indicator light (p) is illuminated.

 Make sure that the charging cables to be used are rated for 12 V and the

maximum CCA rating of the battery.

Engine switch

position

Leave the engine switch (y) in the RUN position while the generator is operating.

Connecting

and charging

a battery

Follow the procedure below to connect and charge a battery.

1. Connect the positive terminal (v1) (red) on the generator to the positive (+)

battery terminal.

2. Connect the negative terminal (v2) (black) on the generator to the negative (-)

battery terminal.

3. Charge the battery for the recommended length of time prescribed by the

battery manufacturer.

WARNING

Personal injury hazard. Battery acid is corrosive to metallic surfaces and harmful to

human skin.

f Wear protective clothing, goggles and gloves when working near batteries.

f If battery acid contacts the skin or eyes, rinse immediately with clear water and

seek immediate medical attention.

WARNING

Explosion hazard. Explosive hydrogen gas is discharged through battery vent holes

during the charging process.

f Do not use open flames or smoke near batteries.

f Do not place metallic objects on or near the battery terminals. Metallic objects in

contact with both poles of the battery will generate extreme heat and potentially

ignite explosive battery gases.

wc_gr00673

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 53 54

No comments

Wacker Neuson GPi 1700 Operator's Manual Page 30