Wacker Neuson GPi 1700 Operator's Manual download pdf (Page 31)

GPi 1700 Operation

wc_tx001234gb.fm 31

Disconnecting

the battery

When the battery is fully charged:

1. Disconnect the cable from the negative (-) terminals of the battery and the

generator.

2. Disconnect the cable from the positive (+) terminals of the battery and the

generator.

If the DC

circuit breaker

activates

The DC circuit breaker may activate while a battery is charging. This may occur for

either of the following reasons:

 Defective battery—check the battery before replacing the DC breaker

 Excessive current draw from a large capacity battery or a totally discharged

battery—use an AC battery charger to charge the battery instead of the

generator.

2.16 Stopping the Generator

Before

stopping

Check with other personnel on the jobsite and let them know that power is being

turned off. Make sure that the power shutdown will not create any hazards by

turning off devices such as pumps, heaters, or lights that may need to be kept on.

Stopping

procedure

To stop the generator:

1. Switch off and disconnect all equipment from the generator.

2. Allow the generator to run at no load for approximately 3 minutes.

3. Turn the engine switch to the STOP position.

2.17 Emergency Shutdown Procedure

Procedure

If a breakdown or accident occurs while the machine is operating, follow the

procedure below:

1. Stop the engine.

2. Turn off the fuel supply.

3. Disconnect tools from the machine.

4. Allow the machine to cool.

5. Contact the rental yard or machine owner for further instructions.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 53 54

No comments

Wacker Neuson GPi 1700 Operator's Manual Page 31