Wacker Neuson GPi 1700 Operator's Manual download pdf (Page 28)

Operation GPi 1700

28 wc_tx001234gb.fm

2.13 Starting the Generator

Starting

procedure

Follow the procedure below to start the machine.

1. Turn the engine switch (y) to the CHOKE position (or the RUN position if the

engine is warm or the ambient temperature is high).

2. Pull the recoil starter (a) slowly until you feel resistance.

3. After you feel resistance, return the recoil starter to its original position and pull

quickly. The engine will start.

4. If you started the machine with the engine switch in the CHOKE position, allow

the engine to run for 20–30 seconds and then turn the engine switch to the RUN

position.

5. Check to make sure that the pilot indicator light (p) is illuminated. This indicates

that the generator is operating properly.

Troubleshooting

If the engine does not start after several attempts, repeat the starting procedure

with the engine switch turned to the RUN position. If the engine still does not start,

refer to the Troubleshooting chapter in this Manual.

CAUTION

Personal injury or machine damage hazards. Starting the generator with equipment

attached can damage the generator or the equipment. Unexpected equipment

start-up can cause personal injury.

f Disconnect all equpment from the generator before starting it.

wc_gr006656

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 53 54

No comments

Wacker Neuson GPi 1700 Operator's Manual Page 28